Use the below instructions to program a URC2135 WOW cable remote to control a Zvox speaker.
1. Press the letter key for the device type that you wish to set up.
Press the B key for Audio Device setup (Since we are setting up a ZVOX)
2. Press and hold the OK and MUTE keys simultaneously until the POWER key blinks twice.
3. Using the digit keys on the remote, enter the programing code.
Press the B key for Audio Device setup (Since we are setting up a ZVOX)
2. Press and hold the OK and MUTE keys simultaneously until the POWER key blinks twice.
3. Using the digit keys on the remote, enter the programing code.
The code I found for the ZVOX is 3913
4. Press and hold the OK and Mute keys until the power key blinks twice.
5. Press the Volume + Key on the Wow Remote.
6. Press the B key (Blue). This is the key for the Audio Device.
4. Test the remote to confirm that it controls your device as expected. If it does not, try again using the next code listed (Step 3).
2332
2334