Silver Comcast Xfinity Remote


Comcast DVR 3-Device Universal Remote Control

These instructions describe how to configure your Comcast cable remote to control the volume from your ZVOX Audio system and not from your TV.The following instructions apply to any TV brand except Panasonic. If you have a Panasonic TV, use the alternate instructions below.  


FOR ANY TV BRAND EXCEPT PANASONIC:

Part 1: 


For Soundbases on the front panel of the ZVOX Audio speaker (570, 670, 770): 

 

a) While the speaker is ON Press and hold down the Mute & Volume Up buttons until you see “PS” on the display.
b) Release the buttons and immediately
c) Press and release the Volume Up button until you see “PS-5” (“PS-3” for Panasonic TV)
d) Wait until the “PS-5” display disappears.


 

For systems with the Other Settings Button on remote (AV200, AV201, AV155, AV157, AV203, New Version SB380, SB500, SB700):


While the speaker is ON press and hold Other Settings for 5 seconds until PS-0 starts flashing then release and adjust with the remotes volume button, move it to PS-5.



For Original SB Soundbars (SB380, SB400, SB500, SB700):


a) While the speaker is ON Press and hold down the Mute & Volume Up buttons on the side of the speaker until you see “PS” on the display.
b) Release the buttons and immediately
c) Press and release the Volume Up button until you see “PS-5” (“PS-3” for Panasonic TV)
d) Wait until the “PS-5” display disappears.


 

Part 2: 

Configure your Comcast remote
Activate the AUX on the Comcast remote control, press AUX once. Then press and hold SETUP until the AUX key blinks twice, then release Setup.
2. Enter 1-0-0-4-7. The AUX key will blink twice.

Assign ZVOX code to the Aux button
1. Press AUX once, then press and hold Setup until the AUX key blinks twice, release Setup.
2. Enter 1-0-2-5-0. The AUX key will blink twice.


Lock the volume buttons to the ZVOX
1. Press AUX once. Then, press and hold Setup until the AUX key blinks twice, release Setup.
2. Enter 9 - 9 - 3 (the AUX key blinks twice) and then press AUX once. The AUX key will blink twice.
3. Press the CABLE button once. You have just completed the programming. Now, when you press VOL+, VOL-, or Mute, the volume of the ZVOX system is controlled regardless of whether the Comcast remote is in the TV mode or Cable mode.