AT&T U-verse S10-S2 Remote Control:

 

These instructions describe how to configure your AT&T U-verse remote to control the volume from your ZVOX

Audio system and not from your TV. These instructions apply to ZBase 580, ZBase 555 and ZVOX V-Series

systems The following instructions apply to any TV.


Part 1: Configure your AT&T remote


Assign code to the AUX button


1. On the AT&T remote control, press AUX once. 

2. Press and hold AUX, then press and hold the

OK key then release both keys simultaneously. 

All the mode keys should flash twice. 

3. Enter 6-0-1-0. -The AUX key will light up for 2 seconds.

Lock the volume buttons to the ZVOX


1. Press and hold AT&T key, then press and hold the

OK key then release both keys simultaneously. 

All the mode keys should flash twice. 

2. Enter 9-5-5.

The AT&T key will flash twice.

3. Press AUX. 

The AUX key will light up for 2 seconds.


Part 2: Configure your ZVOX system


Locate the instruction sheet entitled "Your Current TV Remote Can Control Your ZVOX System" 


1. Follow the instructions on that page for putting the

ZVOX system into its learning mode.

2. Using the AT&T remote, program the volume upvolume downmute and power keys as shown on the page. You have just completed the programming. The volume of the ZVOX system is now controlled by the AT&T remote no matter which control mode (AT&T, TV or DVD) is set on the AT&T remote.