Part 1: Configure the ZVOX speaker



For Soundbases (570, 670, 770):

 

On the front panel of the ZVOX Audio speaker: 


a) While the speaker is ON Press and hold down the Mute & Volume Up buttons until you see “PS” on the display.
b) Release the buttons and immediately
c) Press and release the Volume Up button until you see “PS-1”
d) Wait until the “PS-1” display disappears. 

 

For systems with the Other Settings Button on remote (AV200, AV201, AV155, AV157, AV203, New Version SB380, SB500, SB700):


While the speaker is ON press and hold Other Settings for 5 seconds until PS-0 starts flashing then release and adjust with the remotes volume button, move it to PS-1.


For SB Soundbars (SB380, SB400, SB500, SB700):


a) While the speaker is ON Press and hold down the Mute & Volume Up buttons on the side of the speaker until you see “PS” on the display.
b) Release the buttons and immediately
c) Press and release the Volume Up button until you see “PS-1”
d) Wait until the “PS-1” display disappears.

 


Part 2: Program the ZVOX into the AUX function on the RC122 remote


1.  Press and hold the Select/OK button and the AUX button until all the device keys blink twice, Then enter “3527”.

2.  All device keys should blink three times.  This is the indication that the code was accepted.



Part 3: Lock the volume control on the RC122 remote 


Press and hold the Select/OK button and the CBL button until all the device keys blink twice, then enter “993" and then press the AUX device key.  



Your RC122 is now programmed to control your ZVOX.