Programming a Comcast/Xfinity XR2 remote to control a ZVOX speaker
Part 1: Configure the ZVOX speaker
For Soundbases (570, 670, 770):
On the front panel of the ZVOX Audio speaker:
a) While the speaker is ON Press and hold down the Mute & Volume Up buttons until you see “PS” on the display.
b) Release the buttons and immediately
c) Press and release the Volume Up button until you see “PS-1”
d) Wait until the “PS-1” display disappears.
For systems with the "Other Settings Button" on remote (AV200/201, AV155, AV157, AV203, New Version SB380, SB500, SB700):
While the speaker is ON press and hold Other Settings for 5 seconds until PS-0 starts flashing then release and adjust with the remotes volume button, move it to PS-1.
For SB Soundbars (SB380, SB400, SB500, SB700):
a) While the speaker is ON Press and hold down the Mute & Volume Up buttons on the side of the speaker until you see “PS” on the display.
b) Release the buttons and immediately
c) Press and release the Volume Up button until you see “PS-1”
d) Wait until the “PS-1” display disappears.
Part 2: Configure the XR2 remote
1) Turn on the ZVOX speaker
2) Press and hold the "Setup" button on the XR2 remote. The "All Power" button changes from red to green.
3) Enter 31758.
4) If the code is entered correctly, the status LED will blink Green twice. If the status LED blinks red then green, the code was not entered correctly. Check that you are entering the correct code and try again.
5) Use the XR2 remote to control the ZVOXs volume up/down, mute, and power. If the ZVOXis not responding to the XR2 remote, go back to step 2, then use the code 31759 in step 3.
The XR2 remote is now programmed to control the ZVOX speaker
